Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
DIY
Pin-out for the edge connector?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="tschrama" data-source="post: 147446" data-attributes="member: 3457"><p>Power dissipation will be entirely dominated by the heaters: 6.3V x 300mA = 2W. Cold current will be higher thg :!: </p><p></p><p>four triodes: 4mA</p><p>some low voltage logic stuff: 20mA max. </p><p></p><p>I dont think the induvidual modules have, or are, fuse protected. But I would expect the HV and Heater current to be fuse protected.</p><p></p><p>I think my HV for the modules was closer to 350V. It depends offcourse on the number of modules inserted. One of the cement HV drop resistors was faulty in mine. I have only a replacement for halve the value, so my HV is a bit higher still.</p></blockquote><p></p>
[QUOTE="tschrama, post: 147446, member: 3457"] Power dissipation will be entirely dominated by the heaters: 6.3V x 300mA = 2W. Cold current will be higher thg :!: four triodes: 4mA some low voltage logic stuff: 20mA max. I dont think the induvidual modules have, or are, fuse protected. But I would expect the HV and Heater current to be fuse protected. I think my HV for the modules was closer to 350V. It depends offcourse on the number of modules inserted. One of the cement HV drop resistors was faulty in mine. I have only a replacement for halve the value, so my HV is a bit higher still. [/QUOTE]
Verification
Post reply
Modular Amps
DIY
Pin-out for the edge connector?
Top