Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Egnater / Randall Modular Amps
RM4 Schematic
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Kapo_Polenton" data-source="post: 114001" data-attributes="member: 2642"><p>Also possible it is a cold solder joint.. someone tried heating from the top and jamming the cap in rather than going from the underside of the board. (which to do usually means getting that PCB up) </p><p></p><p>Oh, while you are in there, check the values by your presence pot. Earlier Randalls were much darker than the later revision presence boards. There are a few threads on this forum on that very subject... i think they are in this section. JF outlined the right values.</p></blockquote><p></p>
[QUOTE="Kapo_Polenton, post: 114001, member: 2642"] Also possible it is a cold solder joint.. someone tried heating from the top and jamming the cap in rather than going from the underside of the board. (which to do usually means getting that PCB up) Oh, while you are in there, check the values by your presence pot. Earlier Randalls were much darker than the later revision presence boards. There are a few threads on this forum on that very subject... i think they are in this section. JF outlined the right values. [/QUOTE]
Verification
Post reply
Modular Amps
Egnater / Randall Modular Amps
RM4 Schematic
Top
