That would basically be a Naylor Superdrive. Thats what the naked is, just built on a Marshall power section.
I plan on building this mod at some point.
replace c3 with a 0.0047uf (or just tack another 0.0022uf to the existing one)
see if that gets you where you want to be.
I'll revisit my DS soon, have several projects going at once right now.
Nice work. I was in the same situation, I bought a used RM100 no foot switch.
I was actually planning to do the same thing as I have several arduinos laying around, I lucked out and found a new in box rf3 footswitch for $50 on ebay.
Nice work. Sounds rad!
BTW you can lower the values of r38 and r37 (try 2.7k) to help compensate for the lower voltage. It wont raise the voltage much but it helps it be less saggy and more clear.
Awesome, you are welcome.
I have only one clean MTS module, and its the "clean" module. So far I have not spent much time on it. I have however replaced all the film caps with orange drop 716p caps. That made a nice improvement. At some point I will sketch out the schematic so I can know what...
never tried a kh3, but things you can tweek for taming highs:
1). what tubes? if it has EH 12ax7's (bright tubes) take those out and install some JJ 12ax7s
2). Install a 250pf - 500pf cap in the tube riser board c1t or c2t spot
3). of course c3. I tend to like 0.0022uf there. CrunchBunch...
Yes, and no. I had the bass knob at 1/3, mids at 1/2, and Treb. Dimed
It has plenty bass on tap, I just had it rolled back to keep my phone mic from farting out.