Recent content by KH Guitar Freak

Vintage 30s and H30s user here. Love them...

Another update: Installed the matched quad of Winged C 6L6s into my RM100KH, and set the bias to 40mV for each valve. Sounds good now. In fact, more clarity and definition over the stock JJ 6L6s. Schweet... 8)

Update: I think all I need to work out now is the plate voltages that the MTS series uses. Some have mentioned that the plate voltage is 500V. If that is correct, I can definitely work out what the bias range would be...

Awesome. Those must be one of the first ones that were made after the final prototype... Again, I could be wrong, but perhaps those valves were tested and given a mA rating only because its value was determined based on a known plate voltage???

Hey guys. I need some help. I was looking at this matched quad of Winged C 6L6 for sale locally in my city. The seller has stated that the mA rating for the matched quad is 31.5/2.73. This probably means that the valves are rated at 31mA or 32mA. My question is this. Would I be able to just plug...

I'll check mine when I get the time, and will report back to you and everyone else...

Interesting. What exactly with the light is required to be reseated properly so that it stops flickering???

Anyone knows what is the reason that the pilot light sometimes flickers, and even goes very dim when the amp is turned on???

Hey mate. Cheers for the info. I'm trying to remove the chassis from the head cabinet by removing the eight screws on the underneath of the cabinet, then trying to slide the chassis out via pushing it out from the front to no avail. Perhaps there's an easier way to take out the chassis that I...

Hey guys. I've been using the RF3 footswitch with my Randall RM100KH. Thing is though, I have to run the footswitch with wall wart power to basically power up the footswitch. I was told that if you use a 7 pin MIDI cable to connect the footswitch to the MIDI in jack on the back of the amp, the...