Recent content by schlagdog

PM you on that.

I got a add from Sweetwater and wished it was in September. I would really like to do this if I had the vacation in August and the funds. It really sounds like one of the most enjoyable times and amp geek could ask for.

I use the M13 with all my amps. I use banks 1-3 for pre effects and bank 4 for post. Bank one is just different over drives. Bank 2 is phasers, flange Bank 3 I have a pitch and a pitch set up like a digitech whammy. Then the 4th bank is in the loop and I have a reverb, delay, and I actually use...

I think I put it in front of the fxreturn. I can't really remember for sure because it haven't hooked it all up for a while cause I have been axefx2 for a long time. The axefx2 made the worst hum ever when I first got it and hooded it up to my amp and the box total fixed that also. It's was...

The output level of the M13 using the 4CM Is slightly less then if you just put it in the front of the amp. The FXSEND isn't as hot a signal but I use the screamer always which goes out of the FXSEND in the 4cm so I'm boosting the signal anyways so you can't tell is what I am saying.

It's Ebtech. The same company that your HumX is made by. It's the Hum Eliminator and it goes in your cable signal. I have had good luck with them fixing hum in about everything. I never tried the HumX before so I'm not sure if breaker the ground at the wall is any different. I have a behringer...

Use a ground loop breaker box. The M13 makes lots of hum through alot of things. I bought one when I got my m13 years ago and it takes the hum out of everything. I use the M13 on my amps and I also have the rm4 and it makes it dead quite. It's a handy thing to have on hand all the time and I...

This head makes me wish I was still buying Randall stuff. It's just too awesome!!

That Atomic has been out for quite a while and it's not exactly flying off the shelves.

IF YOU HAVE AN RT2/50 PLEASE PM ME BEFORE YOU POST YOU HAVE. My last deal was within 30 seconds of being done and got poached right out from under me. I would like to not have this happen again because apparently not everyone has the same board courtesy. Both sides of this was all jacked up. SO...

I'm with you on that. One of the firmwares ruined my main patch with a recto red and I never got it to sound the same. P.S. I STILL NEED A RT2/50!

Didn't try the others but I had a long chat with OLA ENGLUND about the AXEFX and the Kemper at NAMM. He told me he was kinda annoyed with the AXEFX2 because he had an Ultra and sold it and said he couldn't hear any difference in the axefx2. He went and schmoozed Kemper because they didn't have...

Like I said a minute ago. The AXEFX really isn't the greatest for emulating the tube power section through a cab especially with a solid state poweramp. My goal was to get it and hopefully scale down and sell some amps. Well I have have it for 4 months and still haven't sold any of my many heads.

I have a carvin and a mosvalve 500 that are both solid state and they sound crappy compared to just running it through any of my 4 tube amp heads power sections. It's a good unit for direct tone but as far as running it through a poweramp as a preamp it is a struggle to get it to really sound...

Yes. Bad dealings but whatever. It's too late now.