Recent content by usrname

Oops! wrong FS.

Footswitch?!!!

PMd on the head.

PM sent!

Grail is sold!

SOLD!

Deluxe is sold pending payment.

SOLD! Thanks MorgMetal!!!

Both MINT condition. All prices are shipped/PPd. Grail: $175 Deluxe: $115

Yeah, that's what I meant; between the carrier and the pots. I'll probably try a third washer to see if that impoves the stability, because if I even touch the module, after getting it to work, it will cut off again.

I can see the washers between the faceplate and pots and there are two each. Would adding a third throw off the screw alignment?

Well, after careful consideration, I think I'll go with an outboard overdrive unit like an od808 or similar. I know finding the right od for me is going to be a journey in itself! Thanks for the help!

Well, I tried almost every solution I found on the forum, save for cleaning the connector inside the amp as I didn't have a problem with any of my other modules, so I didn't think it was necessary. I cleaned the contacts on the module itself, cleaned the tube sockets and worked the tubes in and...

Well, I did buy it used, so I took a gamble, but this is the first time I've had a problem like this, and I have owned at least 15 modules and 4 MTS amps. So, I would say the odds are pretty good. :lol: It is a bit disappointing to know that you can't fully count on this system 100%, but I...

Ok, I fired up the KH-2 with my RM20 and it powered up but the volume was way too low for where the level was set - gain and level were halfway, which usually blows me out of the room! Plus no real increase in gain with it all the way up. So, I tried my other mods and all is well. Then, I...