Search results

You confused me when you said it only goes so far clockwise and it was at 54mv I was like whoa! lol. I don't think it would hurt to remove the tubes and try it like you stated.

Scratch the wuestion on how to take the fuses out. I figured it out lol. I think it's the tubes though. I looked at the fuses and they looked fine, no burn marks or anything like that. Then I switched tube 2 and 3 and now tube 3 isnt reading. When originally 2 and 4 werent reading. Edit: I...

Ok thanks. I wasn't too sure on what it was supposed to be at. Now i'm going to check the fuses. Do they just screw out with a screwdriver or what? Thanks for the help so far guys.

Can you change the power thing on the left? It's currently at 120. What should it be at?

Someone said to set the half power switch to full?? How do I do that?

No not yet. I was really busy yesterday. But i'll look at the fuses later today and if they're not blown ill try swapping the tubes to see if it changes. And i'll report back if I notice anything.

No I had it in the test point for each tube. But when I turned the thing to adjust the bias it didn't read any different.

Ok I recently bought my rm100. Well I installed the tubes and started biasing them. I put my multimeter in tube 1 and I set it to the mv I wanted. Well I moved the red test point to tube 2 and it read.1. Well I then moved it to tube 3 and it read about 35.x. Finally I moved it to tube 4 and it...