Search results

If it's under warranty, contact Synergy directly. My unit showed the same issue and then one day it just went completely silent. Fortunately it was still under warranty and I sent it to an authorized repair shop. They never told me exactly what the problem was but it was acknowledged that it...

The SYN-2 will respond to both PC and PC messages and the MIDI Raider will send both PC and CC messages. The Replifex will let through any MIDI messages (PC or CC) coming from a MIDI controller like the MIDI Raider. Also, the Replifex can be set up to transmit PC changes on a different channel...

Pittbull is gone. Knucklemod still available.

To achieve what you want you'll need two SYN-2 since you can only do one module at a time. The SYN-2 will output identical signals on its L and R outputs.

Selling a couple of mod that I don't use much. Both units in perfect working condition working with no issues whatsoever. I will ship anywhere in the world, just contact me with your address so I can get you a shipping quote. Salvation Mods Knucklemod: $gone Synergy Fryette Pittbull: $gone

I had the same issue, I did several tests with different cabling, guitars, preamps and power amps, and came to the conclusion that my unit was defective. When I contacted synergy they told me that this kind of hum was to be expected with high gain amplification and there was nothing wrong with...

An FX loop is an insert between a preamp section and a power section, in this case of your Marshall head. The FX on/off switch will either bypass (off) or insert (on) the connections of the send/return jacks of the head. Therefore: Switch OFF: you won't be able to hear anything that you have...

If you have FB you're best option would be posting it there https://www.facebook.com/groups/Egnater.MTS/ Bruce Egnater is a very active member and if for any reason it takes him time to reply, there are a few guys who are very knowledgeable, friendly and have schematics of most (if not all) MTS...

I'd try to contact Synergy directly, they might have a solution for that.

They're both 12AX7. You can use a 12at7 on the input tube (bottom one) if you want toblower the gain on the first stage since that tube is V1.

The LED on the unit itself is the SAG control which won't light up if the knob is all the way turn down. Are the LEDs in the modules lighting up? if not, then obviously the unit is not working properly or even getting any power, the problem can be anything from a bad power cable to a blown fuse...

Try the FX returns as inputs, if you can get signal out of the unit that way then the problem should be at the front/rear inputs, which may indicate a bad tube. Otherwise, contact Synergy directly. Some people had issues getting them to reply but the 2 times I had to contact them they were...

Recently there's been questions about running 2 modules in parallel, one method is like the one you're describing where you'll need an ABY box in front of both the SYN2. Aside from this being a lot more compact, I don't see it being any different than running 2 heads/cabs in parallel. Lots of...

Haven't tried the ENGL but all their products are top notch so I would assume it sounds pretty good. Tube power amps I've only tried the Fryette and Mesa amps, they all sound good, just different flavors/tone and headroom. Non tube I've tried ADA microtube power amp, sounded pretty good but...

If you go into the input of the Prophecy, you'll benefit from the "pre-effects" (wha, compressor, hush), if you go into the "effects return" of the Prophecy you won't be able to use them. Since the Prophecy has an input level and the SYN1 has control over the signal level of its effects loop...

I tried a SYN50 in a store before the pandemic, sounded just OK, but I might have not liked the cab/speaker I tried it with. I had the SYN5050 at the same time as a Fryette 2:50:2, they sounded similar, probably the Fryette sounded more open/clear, (not sure how to describe it). I kept the...

As the title says, looking for a Synergy ENGL Powerball. If you have one for sale please do let me know.

I never got to open the unit myself so I can't verify any burnt component. When I asked what the problem was I think the amp tech was too busy to answer, which is understandable, unit was fixed so I left it there. From the (very brief) conversation I had with the amp tech, I infer this is a...

Please correct me if I'm wrong, I haven't seen anything or anywhere where either Synergy or Bogner explicitly confirm that the M, V, C of the schizo switches actually stand for Modern, Vintage and Classic. What is clear is that the M produces the most gain and the most compression while the V...

I contacted Synergy directly and they were very fast to reply. Fortunately my unit was still on warranty (only a month left!) so I had to send the unit to an authorized repair shop. I was told that this particular unit was blowing fuses. I don't know if it was the mains fuse or an internal one...