I just remember when we've got a euro around 1.6 usd when i found my rickenbacker 12 strings from US :roll:
I confirm that Thomann is like Sweetwater, they are realy serious and i still bought a lot of stuff with them
Take your revenge and good deals :wink:
Do you sell the M4 without the mods ?
I still have all of them (including the JF)
If you're right could you give me a price for the M4 only ?
Thanks
Thierry
So if i put a load box as a koch
http://www.koch-amps.com/lb120-loadbox.html
Without any speaker after, i'm just going to product warm in my studio but it's protect the power amp
And my rm1250 will work as three rm4 ...
I understand what you wrote but if i let as standbye or the master at 0 i"ve got no signal at the slave out (designed as to be the power amp link)
So where do i found the signal ? Must i use the fx loop ?
I have a rm1250 that i find great but i used it only as a preamp and the sound is going directly with the play out ot my 2/50/2
The question is that it's not good for a power amp to be up without speaker behind
So do you thing i may put a dummy load like this http://www.k4eaa.com/dummy.html...
In the M4 there is the push switch near the midi connector that can allow or disallow the phamtom power to pin 4 and 5
Do you know if its on when the button is inside (down) our outside (up) ?
On my M4 i've go too an external switch near the tubes and do you know what is it for ? It seems to...
The problem is taht in the rm4 you've got 4 + 2 switch and in the rm1250 you've got 8 together
It's difficult to find common thing
I asked to randall, they give me the CC configure but no answer for the switch configuration
Thanks for your answer
The mark of the choice of the Voltage is on the right and that were i put it.
The problem of using an adapter for 110V is to add a new buzz source that i worked to eliminate everywhere with the other elements
I try to contact master jedi rob
I read it but the problem is that there is nothing about the internal switch on the owner manual of the rm1250 and the switch are not the same than in the rm4
There is not rm1250 midi manual ....
Does anybody know how do the eight internal switch of the rm1250 work ?
I need to choose the midi channel et disable the phantom power
If there is a rm1250 jedi master somewhere ?
I explain, i've got a rm4 from US
I change it to the 240V and when i turn on, i've got a little buzz and the fuse burn (or blow sorry about my frenchy english)
I change the fuse and all are burned immediatly without buzz
I test all the fuse inside and they are OK
So i've got a 110V...
I think that if i put the S2-1 and S2-2 at off they will be no phantom power in the pin
Is there somewhere anything about how works the internal switch of the rm1250 to choose the midi channel too ?