Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
General Forum Information
Off Topic
Cab Help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="onegunguitar" data-source="post: 12710" data-attributes="member: 766"><p>The ohms are the important factor.They should ideally match(each cab having the same ohm rating). The V2 goes down to 2 ohms so you should be ok. If you run 2-16 ohm cabs,the load would be 8 ohms,2-8 ohms would be a 4 ohm load and 2-4's would be a 2 ohm load.Whew!! The V2 does it automatically and even if your cabs don't match,you should be ok, like I said,since it goes down to 2 ohms on the head. As far as left/right outs,it don't matter,they are not stereo outs since it is a mono head. :twisted:</p></blockquote><p></p>
[QUOTE="onegunguitar, post: 12710, member: 766"] The ohms are the important factor.They should ideally match(each cab having the same ohm rating). The V2 goes down to 2 ohms so you should be ok. If you run 2-16 ohm cabs,the load would be 8 ohms,2-8 ohms would be a 4 ohm load and 2-4's would be a 2 ohm load.Whew!! The V2 does it automatically and even if your cabs don't match,you should be ok, like I said,since it goes down to 2 ohms on the head. As far as left/right outs,it don't matter,they are not stereo outs since it is a mono head. :twisted: [/QUOTE]
Verification
Post reply
General Forum Information
Off Topic
Cab Help
Top