Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Egnater / Randall Modular Amps
KT66 Tubes in MOD50, voltage/current draw ok?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="joey_truelove" data-source="post: 125889" data-attributes="member: 95"><p>If the PT can handle EL34s it can handle KT66s as these draw slightly less heater current. As for bias: treat these as 30W 6L6GCs for best sound. If biased cold they will sound hard and edgy, so they need a little heat to soften up and sound their best. Remeber these were down-rated when they didn't hold up so well in amps with high plate voltage (think JTM 45/100s).</p></blockquote><p></p>
[QUOTE="joey_truelove, post: 125889, member: 95"] If the PT can handle EL34s it can handle KT66s as these draw slightly less heater current. As for bias: treat these as 30W 6L6GCs for best sound. If biased cold they will sound hard and edgy, so they need a little heat to soften up and sound their best. Remeber these were down-rated when they didn't hold up so well in amps with high plate voltage (think JTM 45/100s). [/QUOTE]
Verification
Post reply
Modular Amps
Egnater / Randall Modular Amps
KT66 Tubes in MOD50, voltage/current draw ok?
Top