Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Synergy Amps & Modules
Lynch Box Serial Loop Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="kinder5150" data-source="post: 65404" data-attributes="member: 2375"><p>Run down of what happened today:</p><p></p><p>-Bumped Line 6 M9 pedal into the corner of the amp where the power and standy buttons are. Made a loud pop. Lost half of my volume. </p><p>-Jiggled all cables on amp.</p><p>-When unplugging and plugging back in the 1/4's to the serial send/return, this retuned volume to normal, but made loud pop everytime I plugged into the loop.</p><p>-Played more, but popped again, and lowered the level.</p><p>-Changed fx loop preamp tube. Seems to have worked. </p><p>-Preamp tube, before change, barely lit. Tube near the input lit very well. PI preamp tube not as bright. </p><p></p><p>Should all the preamp tubes be somewhat the same brightness?</p><p>Should I think that my fx preamp tube was causing the pop and volume loss, or maybe a power switch is bad since that is where I bumped into the amp with the pedal? Thanks.</p></blockquote><p></p>
[QUOTE="kinder5150, post: 65404, member: 2375"] Run down of what happened today: -Bumped Line 6 M9 pedal into the corner of the amp where the power and standy buttons are. Made a loud pop. Lost half of my volume. -Jiggled all cables on amp. -When unplugging and plugging back in the 1/4's to the serial send/return, this retuned volume to normal, but made loud pop everytime I plugged into the loop. -Played more, but popped again, and lowered the level. -Changed fx loop preamp tube. Seems to have worked. -Preamp tube, before change, barely lit. Tube near the input lit very well. PI preamp tube not as bright. Should all the preamp tubes be somewhat the same brightness? Should I think that my fx preamp tube was causing the pop and volume loss, or maybe a power switch is bad since that is where I bumped into the amp with the pedal? Thanks. [/QUOTE]
Verification
Post reply
Modular Amps
Synergy Amps & Modules
Lynch Box Serial Loop Problem
Top