p o w e r

[iekobrid]

I know there was a guy here messing with a Mesa Road King power section but never heard of any results....I think that would be the final key is a much more programmable power section....I would be willing to pay top dollar for that...Especially if Bruce were to design it....

Speaking of top dollar, anyone ever laid their hands on one of these?


London STUDIO Power Amp, $4700

' two complete 0-to-25W [adjustable power scaling] amplifiers in one low-profile 2U chassis. '

' T-U-P switch (Triode/Ultra-linear/Pentode) '

' bias method and level can be set with the TWEED switch: providing pure fixed-bias, pure cathode-bias or a mix of both. Access the sound of true class-A performance'

' Any octal power tube with the standard pin-out can be fitted in pairs or in any combination: 6CA7, 6L6, 6V6, 5881, 6550, EL-34, KT-66, KT-77, KT-88, or any variant '

' speaker matching is left to the MATCH switch. Set it for whatever sounds best to you. Our output transformers are rugged and will not be hurt by impedance "mismatches". Like all Power Scaled amps from London Power, you can operate STUDIO POWER AMP without a load and simply go direct into a board. '

 

[iekobrid]

Or even one of these?

Milbert GAGA, $ ?

Variable Headroom ("H") more distortion, less volume

* Adjusts power vs overload distortion.
* From full power down to milli-Watts ("bedroom" level).
* Maintains feel and response at all power levels.
* Not a brown sag, power soak or scaler.
* Sets transconductance without stress, heat or waste.

Auto-Impedance

* Drive any load.
* No 4-, 8- or 16-Ohm settings. Just plug in anything.
* Two parallel 1/4-inch outputs - use either or both.
* Use any wire: Instrument cable works in a pinch.

Broadest tonal palette

* Use any of over 30 power tubes, in any combination.
* Use 2, 3 or 4 tubes. All tubes can be completely different.
* No need for "matched pairs".
* No need for matching tube types.
* AutoBias handles everything - no settings.