Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Rigs & Tones
Rig help with Pod HD500, RM4 and poweramp
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Skyze" data-source="post: 87259" data-attributes="member: 2776"><p>doesnt work that way, because the RM4 doesnt have a bypass in its circuit. The only way I can imagine setting it up is if my poweramp had two inputs on the same channel so that I would have to plug my Pod into it along with the RM4.. which it doesnt.</p><p></p><p>Right now, everything in the pod runs thru the RM4. Even though the RM4 is in the middle, and I can put delays/etc after the RM4.. theres no way to bypass the RM4 itself, its always in the tone. And that essentially means that any Pod amp I wanna use, has to run thru the Blackface RM4.</p><p></p><p>That is probably ideal when I have 4 modules for the RM4, assuming they are good enough (which so far, im not sure im digging it) but its pretty lame the RM4 doesnt come with a bypass configuration, especially when you have empty module slots. Wouldnt that just make obvious sense?</p></blockquote><p></p>
[QUOTE="Skyze, post: 87259, member: 2776"] doesnt work that way, because the RM4 doesnt have a bypass in its circuit. The only way I can imagine setting it up is if my poweramp had two inputs on the same channel so that I would have to plug my Pod into it along with the RM4.. which it doesnt. Right now, everything in the pod runs thru the RM4. Even though the RM4 is in the middle, and I can put delays/etc after the RM4.. theres no way to bypass the RM4 itself, its always in the tone. And that essentially means that any Pod amp I wanna use, has to run thru the Blackface RM4. That is probably ideal when I have 4 modules for the RM4, assuming they are good enough (which so far, im not sure im digging it) but its pretty lame the RM4 doesnt come with a bypass configuration, especially when you have empty module slots. Wouldnt that just make obvious sense? [/QUOTE]
Verification
Post reply
Modular Amps
Rigs & Tones
Rig help with Pod HD500, RM4 and poweramp
Top