Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Egnater / Randall Modular Amps
RM100 Tube failure light and randomly blowing tube fuses
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="mThomasDutch" data-source="post: 146968" data-attributes="member: 2616"><p>I also checked all the resistors immediately around all 4 tube tube sockets. I didn't have the schematic handy, but I was able to at least confirm that the resistors on the visible side of the board all showed the same resistance when measured in circuit. I expected if I had a bad resistor something would have shown up different between them.</p></blockquote><p></p>
[QUOTE="mThomasDutch, post: 146968, member: 2616"] I also checked all the resistors immediately around all 4 tube tube sockets. I didn't have the schematic handy, but I was able to at least confirm that the resistors on the visible side of the board all showed the same resistance when measured in circuit. I expected if I had a bad resistor something would have shown up different between them. [/QUOTE]
Verification
Post reply
Modular Amps
Egnater / Randall Modular Amps
RM100 Tube failure light and randomly blowing tube fuses
Top
