Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Synergy Amps & Modules
Running multiple SYN-2's with Ground Control Pro
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="RMosack" data-source="post: 161127" data-attributes="member: 4099"><p>If you are doing the PC commands, then as long as you change a patch on a controller, the modules should save to it. But that's ONLY if they are actually getting the MIDI command sent to them. IT should be really easy. I used my Boss GT-100 to change Synergy channels this way for a while. You just select a patch, and hold the little button down for a few seconds until it flashes. And you obviously have to do this on each SYN-2. </p><p></p><p>Given the above, it should be easy <u>as long as MIDI is getting there</u>. So check:</p><p>1) You are actually transmitting from your controller</p><p>2) It's going to the MIDI IN on both SYN-2 units</p><p>3) They are set to the correct channel. OMNI should work just fine on both. But if you want to pick a channel, make sure the controller and both of the SYN-2 are set to the same channel.</p></blockquote><p></p>
[QUOTE="RMosack, post: 161127, member: 4099"] If you are doing the PC commands, then as long as you change a patch on a controller, the modules should save to it. But that's ONLY if they are actually getting the MIDI command sent to them. IT should be really easy. I used my Boss GT-100 to change Synergy channels this way for a while. You just select a patch, and hold the little button down for a few seconds until it flashes. And you obviously have to do this on each SYN-2. Given the above, it should be easy [u]as long as MIDI is getting there[/u]. So check: 1) You are actually transmitting from your controller 2) It's going to the MIDI IN on both SYN-2 units 3) They are set to the correct channel. OMNI should work just fine on both. But if you want to pick a channel, make sure the controller and both of the SYN-2 are set to the same channel. [/QUOTE]
Verification
Post reply
Modular Amps
Synergy Amps & Modules
Running multiple SYN-2's with Ground Control Pro
Top