Reply to thread

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Message: <blockquote data-quote="Elric" data-source="post: 163653" data-attributes="member: 4087">For config 1: There's no good reason to power up the 5050 if you are going direct and using the outputs on the SYN2. It'll just age the power tubes quicker. In general, I use 'left' ins/outs when going mono. For config 2: I actually have a syn5050 in amp switcher setup, also. There's no need for any stereo connections. I just run it pure mono and you will see the 'bridged' light on it when you run the power amp. Use the 'use first' output only. Set the output ohms based on the row for bridged mode. I use only one output from the Syn2 into the power amp.</blockquote>