Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Modular Amps
Modules
Synergy Diezel Herbert in MTS problem solved !
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="marl3y" data-source="post: 163666" data-attributes="member: 1737"><p>OK, was finally able to get back at this. Short story... it works just fine. No additional noise or anything like that. I used the 15 VDC pos/neg power supply I listed above and fed it via the 17 VDC supply on the board. Wired it to back of the card connector positions "H" and "J" as Telmar identified. "J" is +15 and "H" is -15 VDC. On the MOD 50 I only added support for the Herbert module in the first slot. There is some circuitry on the "H" connector in the second slot. For the RM100 amps you could use slots 1 and 2, but the third one has the same wiring as the second slot on the MOD 50/RM50. Not sure what it is, as the models don't seem to have anything on this pins, but here's the section of the schematic on the RM100. I can live with just using that one slot for the Herbert module when I want to use it.</p><p></p><p>Here are some pics showing the install and wiring. Thanks for all who have done the hard work and showed interest.</p></blockquote><p></p>
[QUOTE="marl3y, post: 163666, member: 1737"] OK, was finally able to get back at this. Short story... it works just fine. No additional noise or anything like that. I used the 15 VDC pos/neg power supply I listed above and fed it via the 17 VDC supply on the board. Wired it to back of the card connector positions "H" and "J" as Telmar identified. "J" is +15 and "H" is -15 VDC. On the MOD 50 I only added support for the Herbert module in the first slot. There is some circuitry on the "H" connector in the second slot. For the RM100 amps you could use slots 1 and 2, but the third one has the same wiring as the second slot on the MOD 50/RM50. Not sure what it is, as the models don't seem to have anything on this pins, but here's the section of the schematic on the RM100. I can live with just using that one slot for the Herbert module when I want to use it. Here are some pics showing the install and wiring. Thanks for all who have done the hard work and showed interest. [/QUOTE]
Verification
Post reply
Modular Amps
Modules
Synergy Diezel Herbert in MTS problem solved !
Top
