Forums
New posts
Search forums
What's new
New posts
New profile posts
Latest activity
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
General Forum Information
Off Topic
V2 help please
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Synergy/MTS Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="TheAbomb12" data-source="post: 11184" data-attributes="member: 145"><p>hmm... I'm not going to 100% on this, but It looks like that the Amp will know what load to use. </p><p></p><p></p><p>Try this: Set the Switch on the Cab to "Mono" then plug in a speaker cable into the "4 ohm mono" jack on the cab. Finally plug the other end of the cable into the First speaker jack on the V2. </p><p></p><p></p><p>...</p><p></p><p></p><p>Now as for how the cab settings work; there are two modes (obviously) Mono and Stereo. When "mono" is selected, The First Jack is set to 4 Ohms; and the second jack set to 16 ohms. </p><p></p><p>When "stereo" mode is selected; both jacks are set to 8 ohms, and for each jack- only 2 speakers are used. For instance, the Right jack will power the 2 Right speakers and the Left jack will power the 2 left speaker of the cab; (this is in opposition to Mono mode in which 1 Jack controls all of the speakers in the cab. )</p></blockquote><p></p>
[QUOTE="TheAbomb12, post: 11184, member: 145"] hmm... I'm not going to 100% on this, but It looks like that the Amp will know what load to use. Try this: Set the Switch on the Cab to "Mono" then plug in a speaker cable into the "4 ohm mono" jack on the cab. Finally plug the other end of the cable into the First speaker jack on the V2. ... Now as for how the cab settings work; there are two modes (obviously) Mono and Stereo. When "mono" is selected, The First Jack is set to 4 Ohms; and the second jack set to 16 ohms. When "stereo" mode is selected; both jacks are set to 8 ohms, and for each jack- only 2 speakers are used. For instance, the Right jack will power the 2 Right speakers and the Left jack will power the 2 left speaker of the cab; (this is in opposition to Mono mode in which 1 Jack controls all of the speakers in the cab. ) [/QUOTE]
Verification
Post reply
General Forum Information
Off Topic
V2 help please
Top