Patrick
Member
Well it came with Ruby el34BStrs .
One Fuse was blown (tub2) so I replaced tub2 and 3 with GTEL34Ms . After Following GTS own install directions on the box(lackluster at best ) and eurotubes videos on Biasing (Bang On) I finally got to the part where i get to press play (switching the standby).
Tube 2 Fail.
Replaced fuse
Tube 3 and 4 Fail.
Replaced Fuses
Removed Tube 2 and 3
Redid Test
No Problems
...................
GT Suck(SO FAR)
....................
But!!!!!!! Existing Tubes 1 and 4 were checked for bias after removing the GT Tubes and both (Rubys)were biased to 45-46 mV. This is way higher than the manual states. So could this be the cause o fthe GT Tubes Failure?
One Fuse was blown (tub2) so I replaced tub2 and 3 with GTEL34Ms . After Following GTS own install directions on the box(lackluster at best ) and eurotubes videos on Biasing (Bang On) I finally got to the part where i get to press play (switching the standby).
Tube 2 Fail.
Replaced fuse
Tube 3 and 4 Fail.
Replaced Fuses
Removed Tube 2 and 3
Redid Test
No Problems
...................
GT Suck(SO FAR)
....................
But!!!!!!! Existing Tubes 1 and 4 were checked for bias after removing the GT Tubes and both (Rubys)were biased to 45-46 mV. This is way higher than the manual states. So could this be the cause o fthe GT Tubes Failure?