seeker
Well-known member
Received my power amp yesterday, unplugged my Mesa 20/20 and connected the new amp. All settings going into the power amp were untouched. Strange thing is the level settings on the Randall needed to be 2x versus the Mesa 20/20 Dynawatt EL84. I'm wondering why a 100 watt amp has less output than a 20 watt ? The Randall is used, but relatively new, with new Ruby tubes. I suppose I should check the bias levels before I look elswhere.
The ohm settings from the outputs are correct, and running in stereo mode.
Any suggestions ?
Thanks,
Howard
The ohm settings from the outputs are correct, and running in stereo mode.
Any suggestions ?
Thanks,
Howard