Search results

I’ve been curious about the MTS SL++ and SL2 mods. I have a SL++ that has a modified faceplate to resemble a Marshall panel. I haven’t been able to find a definitive answer as to the similarity of these mods or if they indeed are the same and have just changed names. Perhaps one is Egnater and...

I was under the assumption that there were mod head/combos out there that were single module capable only. If there were such a monster out there how could you tell at a glance the difference between a dual module capable and single module head/combo? I know someone with a Mod 50 but he only has...

Anybody know about these adapters as compared to Yellowjacket adapters? Will they work in the Randall MTS line? They're less than half the cost and the VHT brand is a definite plus.

Any comments good or bad? I can score one for $250?.It's the older model with the handles recessed in the side. Thanks?.

After finding out my RM22 has run away bias on one of the tubes they were replaced and the amp given a clean bill of health. In my original post about the amp shutting down I though after checking the bias settings that the tubes were the culprit. My amp tech replaced the tubes and found a...

JF VHT Pitbull mod on ebay: http://www.ebay.com/itm/350778646604?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1438.l2649

My RM22 has a plate voltage reading of 390 volts according to the tech I sent my amp to get fixed under warranty. I thought typical plate voltages for el84's should be in the 250-300v range. If that is true shouldn't the bias point adjustments be well below the recommended 15-22mv even if the...

Maybe I'm losing my mind but for the life of me I can't find the bias voltages for an RM22. HELP!!!!

How does everyone feel about running Ruby tubes with the paper stickers on them? While looking over my newly acquired RM22 the tubes freaked me out a bit. When I went to the Ruby Tubes site the tubes already had the labels on the glass part of the tube. I've had tubes with paper stickers on the...

Since my RM50 is breaking my back hauling it back and forth from jam sessions I'm seriously considering getting a RM22 head. Not sure if I'll be using it with a 4x12 or a 1x12 so I was wondering if I can get some input. I don't have any grand expectations of an 18 watt head blowing the roof off...