Question using RT50/2 and multiple Preamps and MIDI

[FlyingV]

Hello, I read the manual however I have questions based on this being kind of new to me.

I have the RT50/2 and the RM4. I also have a Behringer V-Amp Pro and room left in the rack.

So, can I run both the RM4 AND the Behringer V-Amp Pro to the RT50/2 at the same time? Guitar/V-Amp Pro/RM4/RT50-2/Cabinet? I wouldn't mind being able to run some V-Amp Pro patches thru one of the modules in the RM4 and I have the FCB1010 MDID Controller working with the Behringer V-Amp Pro already. The V-Amp has MIDI Thru and so does the RM4 and RT50/2 so this should all be able to be tied together right?

If anyone would have good "Learn MIDI Routing and Assingment" type links or resources for beginners like me that they want to share I sure would appreciate the tips.

Thanks much.

 

[glpg80]

you could use multiple preamps with the rt2/50, but not at the same exact time. not sure though, when the RT2 is in stereo mode you are using 100 watts of actual power.

how it gets its signal is a different story. i do know that you lose the ability to switch from mono/mono when its in stereo mode because stereo mode is a physical switch on the back of the amp.

they do make effortless pre-amp switching modules for on-the-fly preamp switching. ive seen it in someones rig.. i think it was on this forum?!

also it depends on how you programmed your preamp settings. like.. using continuous mode on your MIDI switcher you could control your chorus, delay, preamp, and mono-channel of the RT2/50 all at once.

maybe someone else with alot of knowledge on this topic can chime in (jugger haha) :wink: