Hi, have a few questions about the setup and configuration for this. I would like to run in 2 modes 1) XLR DI output to my DAW and 2) SYN-5050 mode to a single cab up to max wattage possible (100w?)
For configuration 1 (XLR DI output) . Do I need to power off the SYN-5050 if configured up like page 9 (Connecting SYN-2 to Rack Mount Power AMP) or unplug cables, etc. Also, which of the XLR DI jacks should be used as there are 2 (Left and Right) ? The Left and Right is throwing me off in the docs and not sure what this really means (same mono signal with correct phasing or stereo signal).
For configuration 2 (SYN-5050 powered). I am not using two (2) speaker outputs but actually one (1) to a 4/12 cabinet. This is actually behind an amp switcher. I do see the mono switch and the "use this first" jack, so that makes sense, however; I am curious what is up with both the left and right cables again coming from the SYN-2 as this complicates my amp switcher setup. Or do I just use the right Main out to Chan A (mono), set to mono, and put the speaker cable in the use this first jack?
I also have a SYN-1 that I use for on the run situations and curious if this can be integrated into the above.
Mark C
For configuration 1 (XLR DI output) . Do I need to power off the SYN-5050 if configured up like page 9 (Connecting SYN-2 to Rack Mount Power AMP) or unplug cables, etc. Also, which of the XLR DI jacks should be used as there are 2 (Left and Right) ? The Left and Right is throwing me off in the docs and not sure what this really means (same mono signal with correct phasing or stereo signal).
For configuration 2 (SYN-5050 powered). I am not using two (2) speaker outputs but actually one (1) to a 4/12 cabinet. This is actually behind an amp switcher. I do see the mono switch and the "use this first" jack, so that makes sense, however; I am curious what is up with both the left and right cables again coming from the SYN-2 as this complicates my amp switcher setup. Or do I just use the right Main out to Chan A (mono), set to mono, and put the speaker cable in the use this first jack?
I also have a SYN-1 that I use for on the run situations and curious if this can be integrated into the above.
Mark C